Snmp-Server Group - Dell S4810 Reference Manual

Version 9.0.2.0
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
Changing the value of the SNMP Engine ID has important side effects. A user's
Information
password (entered on the command line) is converted to a message digest
algorithm (MD5) or secure hash algorithm (SHA) security digest. This digest is based
on both the password and the local Engine ID. The command line password is then
destroyed, as required by RFC 2274. Because of this deletion, if the local value of
the Engine ID changes, the security digests of SNMPv3 users is invalid and the users
will have to be reconfigured.
For the remote Engine ID, the host IP and UDP port are the indexes to the
command that are matched to either overwrite or remove the configuration.
Related
show snmp engineID
Commands
are configured on the router.
show running-config

snmp-server group

Configure a new SNMP group or a table that maps SNMP users to SNMP views.
S8410
Syntax
snmp-server group [group_name {1 | 2c | 3 {auth | noauth |
priv}}] [read name] [write name] [notify name] [access access-
list-name | ipv6 access-list-name | access-list-name ipv6
access-list-name]]
To remove a specified group, use the no snmp-server group [group_name
{v1 | v2c | v3 {auth | noauth | priv}}] [read name] [write
name] [notify name] [access access-list-name | ipv6 access-
list-name | access-list-name ipv6 access-list-name]] command.
Simple Network Management Protocol (SNMP) and Syslog
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— displays the SNMP engine and all the remote engines that
snmp — displays the SNMP running configuration.
1565