Fields
Protocol
Example (Brief)
Dell#show ip int brief
Interface
Status
GigabitEthernet 1/0
down down
GigabitEthernet 1/1
down down
GigabitEthernet 1/2
up
GigabitEthernet 1/3
up
GigabitEthernet 1/4
up
GigabitEthernet 1/5
up
GigabitEthernet 1/6
down down
show ip management-route
View the IP addresses assigned to the Management interface.
S4810
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all
connected
summary
static
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
892
Description
States whether IP is enabled (up) or disabled (down) on the
interface.
Protocol
(OPTIONAL) Enter the keyword all to view all IP addresses
assigned to all Management interfaces on the switch.
(OPTIONAL) Enter the keyword connected to view only
routes directly connected to the Management interface.
(OPTIONAL) Enter the keyword summary to view a table
listing the number of active and non-active routes and their
sources.
(OPTIONAL) Enter the keyword static to view non-active
routes also.
EXEC
EXEC Privilege
IP-Address
OK? Method
unassigned
NO
Manual
unassigned
NO
Manual
unassigned
YES Manual
up
unassigned
YES Manual
up
unassigned
YES Manual
up
10.10.10.1
YES Manual
up
unassigned
NO
Manual
administratively
administratively
administratively
IPv4 Routing