Ip Helper-Address - Dell S4810 Reference Manual

Version 7.6.1.0
Version 7.5.1.0
Usage
You can only configure one domain name with the ip domain-name command.
Information
To configure more than one domain name, configure the ip domain-list
command up to six times.
To enable dynamic resolution of hosts, use the following steps:
•
•
To view current bindings, use the show hosts command.
Related
ip domain-list
Commands

ip helper-address

Specify the address of a DHCP server so that DHCP broadcast messages can be forwarded when the
DHCP server is not on the same subnet as the client.
S4810
Syntax
ip helper-address ip-address
To remove a DHCP server address, use the no ip helper-address command.
Parameters
ip-address
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.11.1
IPv4 Routing
Introduced on the S-Series.
Introduced on the C-Series.
specify a domain name server with the ip name-server command
enable DNS with the ip domain-lookup command
— configures additional names.
Enter an IP address in dotted decimal format (A.B.C.D).
Introduced on the S6000.
Added support for IPv6.
Introduced on the S4820T.
Introduced on the Z9000.
853