Dell S4810 Reference Manual page 1563

Hide thumbs Also See for S4810:

Table of Contents

Not enabled.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 9.2(0.0)

Version 9.1(0.0)

Version 8.3.11.1

Version 8.3.7.0

Version 8.4.1.0

Version 7.6.1.0

Version 7.5.1.0

E-Series legacy

Dell Networking OS supports up to 16 SNMP trap receivers.

For the cam-utilization notification option, the system generates syslogs and

SNMP traps when the L3 host table or route table utilization goes above the

If you do not configure this command, no traps controlled by this command are

sent. If you do not specify a notification-type and notification-option,

all traps are enabled.

Simple Network Management Protocol (SNMP) and Syslog

For the snmp notification-type, enter one of the following

optional parameters:

authentication

Introduced on the S6000.

Introduced on the M I/O Aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Added support for copy-config and ecmp traps.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added support for VRRP traps.

Added support for STP and xSTP traps. Introduced on the S-

Introduced on the C-Series.