fip-snooping port-mode fcf
Configure the port for bridge-to-FCF links.
S4810
Syntax
fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-
mode fcf command.
Command
INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Usage
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
Information
fip-snooping port-mode fcoe-trusted
Configure the port for bridge-to-bridge links.
MXL Switch, S4810
Syntax
fip-snooping port-mode fcoe-trusted
To remove the bridge-to-bridge link configuration from the port, use the no fip-
snooping port-mode fcoe-trusted command.
Command
INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
660
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S4820T.
FCoE Transit