Logging History Size - Dell S4810 Reference Manual

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage When you configure the snmp-server trap-source command, the system
Information
messages logged to the history table are also sent to the SNMP network
management station.
Related
show logging
Commands

logging history size

Specify the number of messages stored in the Dell Networking logging history table.
S4810
Syntax
logging history size size
To return to the default values, use the no logging history size command.
Parameters
size
Defaults 1 message
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Simple Network Management Protocol (SNMP) and Syslog
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— displays information logged to the history buffer.
Indicate a value as the number of messages to be stored.
The range is from 0 to 500. The default is 1 message.
1591