Ip Pim Rp-Candidate - Dell S4810 Reference Manual

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
pre-Version
6.1.1.1
Usage First-hop routers use this address by to send register packets on behalf of source
Information multicast hosts. The RP addresses are stored in the order in which they are entered.
RP addresses learned using BSR take priority over static RP addresses. Without the
override option, RPs advertised by the BSR updates take precedence over the
statically configured RPs.

ip pim rp-candidate

To send out a Candidate-RP-Advertisement message to the bootstrap (BS) router or define group
prefixes that are defined with the RP address to PIM BSR, configure a PIM router.
S4810
Syntax
ip pim rp-candidate {interface [priority]
To return to the default value, use the no ip pim rp-candidate {interface
[priority] command.
Parameters
interface
PIM-Sparse Mode (PIM-SM)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the E-Series.
Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
1279