Queue Ingress - Dell S4810 Reference Manual

queue ingress

Assign a WRED Curve to all eight ingress Multicast queues or designate the percentage for the Multicast
bandwidth queue.
S4810
Syntax
queue ingress multicast {linecard slot number port-set number |
all} [wred-profile name]
To return to the default, use the no queue ingress multicast {linecard
slot number port-set number | all} [wred-profile name] command.
Parameters
linecard
number
port-set
number
all
wred-profile
name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.8.0
Version 7.4.1.0
and 6.5.3.0
Usage
This command does not uniquely identify a queue, but rather identifies only a set of
Information
queues. The WRED Curve is applied to all eight ingress Multicast queues.
1352
bandwidth configured is adjusted according to the bandwidth available after
reserving for multicast bandwidth.
Enter the keyword linecard then the line card slot number.
Enter the keywords port-set then the line card's port pipe.
The range is from 0 or 1.
Enter the keyword all to apply to all line cards.
(OPTIONAL) Enter the keywords wred-profile then your
WRED profile name in character format (16 character
maximum). Or use one of the pre-defined WRED profile
names.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series.
Quality of Service (QoS)