Dell S4810 Reference Manual page 743

Version 9.4(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.5.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.4.1.0
Usage
You cannot delete a physical interface.
Information
By default, physical interfaces are disabled (shutdown) and are not assigned to an
IP address or switchport. To place an interface in Layer 2 mode, ensure that the
interface's configuration does not contain an IP address and enter the switchport
command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface
with no default configuration. To delete a tunnel interface, use the no interface
tunnel tunnel-id command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the
next hop to the tunnel destination is over a physical interface. If you select any
other interface as the next hop to the tunnel destination, the tunnel interface does
not operate as an ECMP.
Example
Dell(conf)#int tengigabitethernet 0/0
Dell(conf-if-te-0/0)#exit
Dell(conf)#
Related
interface loopback
Commands
interface null
interface port-channel
interface vlan
show interfaces
Interfaces
Added the support for interfaces.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
— configures a Loopback interface.
— configures a Null interface.
— configures a port channel.
— configures a VLAN.
— displays the interface configuration.
743