Fcoe Transit; Clear Fip-Snooping Database Interface Vlan - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

FCoE Transit

To enable the FCoE Transit feature and configure FIP snooping, use the following Dell Networking

Operating System commands on the S4810 platform.

In a converged Ethernet network, a switch can operate as an intermediate Ethernet bridge to snoop on

FIP packets during the login process on Fibre Channel over Ethernet (FCoE) forwarders (FCFs). Acting as a

transit FIP snooping bridge, the switch uses dynamically created access control lists (ACLs) to permit only

authorized FCoE traffic to transmit between an FCoE end-device and an FCF.

Clear FIP snooping information on a VLAN for a specified FCoE MAC address, ENode MAC address, or

FCF MAC address, and remove the corresponding ACLs FIP snooping generates.

clear fip-snooping database interface vlan {vlan-id} enode

{enode-mac-address} | fcf {fcf-mac-address} | session {session-

mac-address}

session-mac-

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Enter the ENode MAC address to be cleared of FIP snooping

information.

Enter the FCF MAC address to be cleared of FIP snooping

information.

Enter the MAC address for the session to be cleared of FIP

snooping information.

Introduced on the S4820T.

Introduced on the S4810.

FCoE Transit