Msti - Dell S4810 Reference Manual

msti

Configure multiple spanning tree instance, bridge priority, and one or multiple VLANs mapped to the MST
instance.
S4810
Syntax
msti instance {vlan range | bridge-priority priority}
To disable mapping or bridge priority, use the no msti instance {vlan range
| bridge-priority priority} command.
Parameters
msti instance
vlan range
bridge-priority
priority
Defaults default bridge-priority is 32768.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.5.1.0
Usage By default, all VLANs are mapped to MST instance zero (0) unless you use the vlan
Information range command to map it to a non-zero instance.
Multiple Spanning Tree Protocol (MSTP)
Enter the MSTP instance. The range is from zero (0) to 63.
Enter the keyword vlan then the identifier range value. The
range is from 1 to 4094.
Enter the keywords bridge-priority then a value in
increments of 4096 as the bridge priority. The range is from
zero (0) to 61440.
Valid priority values are: 0, 4096, 8192, 12288, 16384, 20480,
24576, 28672, 32768, 36864, 40960, 45056, 49152, 53248,
57344, and 61440. All other values are rejected.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
1121