Parameters
ip-protocol-
number
protocol-type
source
mask
any
host ip-address
destination
bit
operator
Defaults
none
Command
REDIRECT-LIST
Modes
Command
Version 9.4.0.0
History
1262
Enter a number from 0 to 255 for the protocol identified in
the IP protocol header.
Enter one of the following keywords as the protocol type:
•
icmp for internet control message protocol
•
ip for any internet protocol
•
tcp for transmission control protocol
•
udp for user datagram protocol
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x).
Enter the keyword any to specify that all traffic is subject to
the filter.
Enter the keyword host then he IP address to specify a host
IP address.
Enter the IP address of the network or host to which the
packets are sent.
(OPTIONAL) For the TCP protocol type only, enter one or a
combination of the following TCP flags:
•
ack = acknowledgement
•
fin = finish (no more data from the user)
•
psh = push function
•
rst = reset the connection
•
syn = synchronize sequence number
•
urg = urgent field
(OPTIONAL) For TCP and UDP parameters only. Enter one of
the following logical operand:
•
eq = equal to
•
neq = not equal to
•
gt = greater than
•
lt= less than
•
range = inclusive range of ports (you must specify two
ports for the portcommand parameter.)
Introduced on the S4810.
Policy-based Routing (PBR)