Sflow Collector - Dell S4810 Reference Manual

sflow collector

Configure a collector device to which sFlow datagrams are forwarded.
S4810
Syntax
sflow collector {ip-address | ipv6-address} agent-addr {ip-
address | ipv6-address} [number [max-datagram-size number]] |
[max-datagram-size number] [vrf management]
To delete a configured collector, use the no sflow collector {ip-address |
ipv6-address} agent-addr {ipv4-address | ipv6-address} [number
[max-datagram-size number]] | [max-datagram-size number] [vrf
management] command.
Parameters
sflow collector
ip-address |
ipv6-address
agent-addr ip-
address | ipv6-
address
number
max-
datagram-size
number
vrf
management
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
sFlow
Enter the IP address of the collector in dotted decimal
format for IPv4 or x:x:x:x::x format for IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the keyword agent-addr followed by the sFlow agent
IP address in dotted decimal format for IPv4 or x:x:x:x::x
format for IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
(OPTIONAL) Enter the user datagram protocol (UDP) port
number. The range is from 0 to 65535. The default is 6343.
(OPTIONAL) Enter the keyword max-datagram-size then the
size number in bytes. The range is from 400 to 1500. The
default is 1400.
(OPTIONAL) Enter the keyword vrf followed by the keyword
management to configure the collector device
corresponding to the default VRF and the management VRF
respectively.
Added support for VRF.
1543