Show Running-Config Monitor Session - Dell S4810 Reference Manual

Version 8.3.11.1
Version 8.1.1.0
Version 7.7.1.0
Version 7.5.1.0
Version 7.4.1.0
Example
Dell#show monitor session
IP
---------
A
Related monitor session
Commands

show running-config monitor session

Display the running configuration of all monitor sessions or a specific session.
S4810
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show
running-config monitor session command.
Parameters
session-ID
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Port Monitoring
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
SessID Source
Dest IP
------ ------
--------
1 Vl 10
N/A
— creates a monitoring session.
(OPTIONAL) Enter a session identification number. The range
from 0 to 65535.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Destination
-----------
Te 0/8
Dir Mode Source
--- ----
rx Flow N/
1301