Interface Loopback - Dell S4810 Reference Manual

Usage
The interface group command will create all the non-existent VLANs specified
Information
in the range. On successful command execution, the CLI switches to the interface
group context.
The configuration commands inside the group context will be the similar to that of
the existing range command.
Note: For release 9.4(0.0), the group command is supported only for VLANs and
physical interfaces.
Example
Dell(conf)#interface group ?
fortyGigE
gigabitethernet
tengigabitethernet
vlan
Dell(conf)# interface group vlan 1 - 2 , tengigabitethernet
0/0
Dell(conf-if-group-vl-1-2,te-0/0)# no shutdown
Dell(conf-if-group-vl-1-2,te-0/0)# end

interface loopback

Configure a Loopback interface.
S4810
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number
command.
Parameters
number
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Interfaces
FortyGigabit Ethernet interface
GigabitEthernet interface IEEE 802.3z
TenGigabit Ethernet interface
VLAN keyword
Enter a number as the interface number. The range is from 0
to 16383.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
745