Port Channel Commands; Channel-Member - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

Port Channel Commands

A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a single link

according to IEEE 802.3ad. In Dell Networking OS, a LAG is referred to as a Port Channel.

For the S-Series, the maximum port channel ID is 128 and the maximum members per port channel is

Because each port can be assigned to only one Port Channel, and each Port Channel must have at least

one port, some of those nominally available Port Channels might have no function because they could

have no members if there are not enough ports installed. In the S-Series, stack members can provide

those ports.

NOTE: The Dell Networking OS implementation of LAG or Port Channel requires that you configure

a LAG on both switches manually. For information about Dell Networking OS link aggregation

control protocol (LACP) for dynamic LAGs, refer to the

chapter. For more information about configuring and using Port Channels, refer to the Dell

Networking OS Configuration Guide.

Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.

channel-member interface

To delete an interface from a Port Channel, use the no channel-member

interface command.

Not configured.

INTERFACE PORTCHANNEL

Link Aggregation Control Protocol (LACP)

(OPTIONAL) Enter any of the following keywords and slot/

port or number information:

For a 100/1000 Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.