Match Ip Dscp - Dell S4810 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.11.1
Version 8.3.7.0
Usage To access this command, enter the class-map command. After the class map is
Information
identified, you can configure the match criteria. For class-map match-any, a
maximum of five ACL match criteria are allowed. For class-map match-all,
only one ACL match criteria is allowed.
Related
class-map
Commands

match ip dscp

Use a differentiated services code point (DSCP) value as a match criteria.
S4810
Syntax
match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value]
To remove a DSCP value as a match criteria, use the no match {ip | ipv6 |
ip-any} dscp dscp-list [[multicast] set-ip-dscp value] command.
Parameters
ip
ipv6
ip-any
dscp-list
set-ip-dscp
value
Defaults none
Command CLASS-MAP CONFIGURATION (config-class-map)
Modes
Quality of Service (QoS)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the Z9000.
Introduced on the S4810.
— identifies the class map.
Enter the keyword ip to support IPv4 traffic.
Enter the keyword ipv6 to support IPv6 traffic.
Enter the keyword ip-any to support IPv4 and IPv6 traffic.
Enter the IP DSCP values that is to be the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is from
0 to 63.
(OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
1339