Policy-Map-Output - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

The input policy map is used to classify incoming traffic to different flows using

class-map, QoS policy, or incoming packets DSCP. This command enables Policy-

Map-Input Configuration mode (conf-policy-map-in).

When changing a "service-queue" configuration in a QoS policy map, all QoS rules

are deleted and re-added automatically to ensure that the order of the rules is

maintained. As a result, the Matched Packets value shown in the "show qos

statistics" command is reset.

service-queue

policy-aggregate

using policy maps.

service-policy input

policy-map-output

Create an output policy map.

policy-map-output policy-map-name

To remove a policy map, use the no policy-map-output policy-map-name

Quality of Service (QoS)

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

— assigns a class map and QoS policy to different queues.

— allows an aggregate method of configuring per-port QoS

— applies an input policy map to the selected interface.

Enter the name for the policy map in character format (32

characters maximum).