Passive-Interface - Dell S4810 Reference Manual

Command ROUTER OSPF
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage
To enable OSPF on an interface, the network area command must include, in its
Information
range of addresses, the primary IP address of an interface.
If you delete all the network area commands for Area 0, the show ip ospf
command output does not list Area 0.

passive-interface

Suppress both receiving and sending routing updates on an interface.
S4810
Syntax
passive-interface {default | interface}
To enable both the receiving and sending routing, use the no passive-
interface interface command.
To return all OSPF interfaces (current and future) to active, use the no passive-
interface default command.
Parameters
default
interface
Open Shortest Path First (OSPFv2 and OSPFv3)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced to all platforms.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: An interface can be attached only to a single OSPF area.
Enter the keyword default to make all OSPF interfaces
(current and future) passive.
Enter the following keywords and slot/port or number
information:
1179