Show Ipv6 Neighbors - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

hardware_addr

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.11.1

Version 8.3.7.1

show ipv6 neighbors

Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor

addresses stored on the control processor (CP).

show ipv6 neighbors [ipv6-address] [cpu {rp1 [ipv6-address] |

rp2 [ipv6-address]}] [interface interface]

ipv6-address

Neighbor Discovery Protocol (NDP)

Enter the keyword interface then the interface type and

slot/port or number information:

For a Fast Ethernet interface, enter the keyword

fastEthernet then the slot/port information.

For a Port Channel interface, enter the keywords port-

channel then a number.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Enter the IPv6 address of the neighbor in the x:x:x:x::x

NOTE: The :: notation specifies successive hexadecimal

fields of zero.