Ip Ssh Server - Dell S4810 Reference Manual

Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
Enabling RSA authentication allows the user to log in without being prompted for a
Information
password. In addition, the OpenSSH compatible SSHv2 RSA public key must be
added to the list of authorized keys (ip ssh rsa-authentication my-
authorized-keys device://filename command).

ip ssh server

Configure an SSH server. SSH server is enabled by default.
S4810
Syntax
ip ssh server {enable | port port-number} [version {1 | 2}]
To disable SSH server functions, use the no ip ssh server enable command.
Parameters
enable
port port-
number
[version {1 | 2}]
Security
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
Enter the key word enable to start the SSH server.
(OPTIONAL) Enter the keyword port then the port number
of the listening port of the SSH server. The range is from 1 to
65535. The default is 22.
(OPTIONAL) Enter the keyword version then the SSH
version 1 or 2 to specify only SSHv1 or SSHv2.
1511