Redundancy Disable-Auto-Reboot - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:
Table of Contents

Advertisement

Usage
If you disable auto failover, enter the redundancy auto-failover-limit
Information
(without any parameters) to set auto failover to the default parameters (Count 3,
Period 60 minutes). To view the redundancy status, use the show redundancy
command.
When you change one or both of the optional parameters, Dell Networking OS
checks that the interval between auto failovers is more than five (5) minutes. If the
interval is less, Dell Networking OS returns a configuration error message.

redundancy disable-auto-reboot

Prevent the system from auto-rebooting the failed module.
S4810
Syntax
redundancy disable-auto-reboot [rpm| card number | all]
To return to the default, use the no redundancy disable-auto-reboot rpm
command.
Parameters
rpm
Default
Disabled (that is, the failed module is automatically rebooted).
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.1.1.0
Version 7.6.1.0
696
Enter the keyword rpm to disable auto-reboot of the failed
RPM.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added the all option.
Introduced on the E-Series ExaScale.
Introduced on the E-Series
High Availability (HA)

Advertisement

Table of Contents
loading

Table of Contents