Dell S4810 Reference Manual page 824

To delete a transform set, use the no crypto ipsec transform-set name
{ah-authentication {md5|sha1|null} | esp-authentication {md5|
sha1|null} | esp-encryption {3des|cbc|des|null}} command.
Parameters
name
ah-
authentication
esp-
authentication
esp-encryption
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2)
824
Enter the name for the transform set.
Enter the keywords ah-authentication then the
transform type of operation to apply to traffic. The transform
type represents the encryption or authentication applied to
traffic.
• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1)
authentication.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
Enter the keywords esp-authentication then the
transform type of operation to apply to traffic. The transform
type represents the encryption or authentication applied to
traffic.
• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1)
authentication.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
Enter the keywords esp-encryption then the transform
type of operation to apply to traffic. The transform type
represents the encryption or authentication applied to traffic.
• 3des — Use 3DES encryption.
• cbc — Use CDC encryption.
• des — Use DES encryption.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
Introduced on the Z9000, S4810, and S4820T.
Internet Protocol Security (IPSec)