Protocol-Tunnel - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

in | out | both

vlan vlan-id

Debug disabled.

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.5.1.0

Version 8.3.7.0

Version 8.2.1.0

Version 7.4.1.0

protocol-tunnel

Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.

protocol-tunnel {rate-limit rate| stp}

To disable protocol tunneling for a Layer 2 protocol, use the no protocol-

tunnel command.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

Enter the keyword in, out, or both to debug incoming

interfaces, outgoing interfaces, or both incoming and

outgoing interfaces.

Enter the keyword vlan then the VLAN ID. The range is from

Enter the keyword count then the number of debug

outputs. The range is from 1 to 100.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the C-Series, E-Series, and E-Series ExaScale.

Service Provider Bridging