Enable Password - Dell S4810 Reference Manual

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Related
line
Commands
ip access-list standard
the IP address.
ip access-list extended
IP addresses or protocols.

enable password

Change the password for the enable command.
S4810
Syntax
enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type]
password [level level] command.
Parameters
level level
encryption-
type
password
Defaults No password is configured. level = 15.
1456
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— applies an authentication method list to the designated terminal lines.
— names (or selects) a standard access list to filter based on
— names (or selects) an extended access list based on the
(OPTIONAL) Enter the keyword level then a number as the
level of access. The range is from 1 to 15.
(OPTIONAL) Enter the number 7 or 0 as the encryption type.
Enter a 7 then a text string as the hidden password. The text
string must be a password that was already encrypted by a
Dell Networking router.
Use this parameter only with a password that you copied
from the show running-config file of another Dell
Networking router.
Enter a text string, up to 32 characters long, as the clear text
password.
Security