Protocol Spanning-Tree Rstp - Dell S4810 Reference Manual

hello-time

protocol spanning-tree rstp

To configure RSTP, enter RSTP mode.
S4810
Syntax
protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
Defaults Not configured
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.1
Usage RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the
Information system, use the no disable command from RSTP mode.
Example
Dell(conf)#protocol spanning-tree rstp
Dell(config-rstp)##no disable
Related disable
Commands
Rapid Spanning Tree Protocol (RSTP)
— changes the time interval between BPDUs.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— disables RSTP globally on the system.
1431