Dell S4810 Reference Manual page 1098

output
interface
output-range
interface
vlan vlan-id
Defaults Not configured.
Command CONFIGURATION
Modes
Command
The following is a list of the Dell Networking OS version history for this command.
History
Version 9.3(0.0)
Usage When a multicast source and multicast receivers are in the same VLAN, you can
Information configure a router so that multicast traffic is switched only to the ports assigned to
a VLAN that is associated with a static multicast MAC address. However, before you
can configure a static MAC address and associate it with a VLAN used to switch
Layer 2 multicast traffic, you must first enable the router for Layer 2 multicast
switching with the ip multicast-mode l2 command.
Example
mac-address-table static 01:00:5E:01:00:01 {multicast vlan
(Multicast)
2 output—range Te 0/2,Te 0/3}
1098
NOTE: Use this option if you want multicast functionality
in an L2 VLAN without IGMP protocols.
For a multicast MAC address, enter the keyword output
then one of the following interfaces for which traffic is
forwarded:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a multicast MAC address, enter the keyword output-
range then one of the following interfaces to indicate a
range of ports for which traffic is forwarded:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keyword vlan then a VLAN ID number from 1 to
4094.
Added support for multicast MAC address on the MXL
platform.
Microsoft Network Load Balancing