Dell S4810 Reference Manual page 1229

null
Defaults Not configured.
Command ROUTER OSPFv3
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Version 8.4.2.0
Version
8.3.19.0
Usage
Before you enable IPsec encryption on an OSPFv3 interface, first enable OSPFv3
Information
globally on the router. Configure the same encryption policy (same SPI and keys)
on each interface in an OSPFv3 link.
An SPI value must be unique to one IPsec security policy (authentication or
encryption) on the router.
When you configure encryption for an OSPFv3 area with the area encryption
command, you enable both IPsec encryption and authentication. However, when
you enable authentication on an area with the area authentication command,
you do not enable encryption at the same time.
If you have enabled IPsec authentication in an OSPFv3 area with the area
authentication command, you cannot use the area encryption command in
the area at the same time.
The configuration of IPsec encryption on an interface-level takes precedence over
an area-level configuration. If you remove an interface configuration, an area
encryption policy that has been configured is applied to the interface.
To remove an IPsec encryption policy from an interface, enter the no area area-id
encryption spi number command.
Related
ipv6 ospf encryption
Commands
interface.
show crypto ipsec policy
Open Shortest Path First (OSPFv2 and OSPFv3)
Causes an encryption policy configured for the area to not
be inherited on the interface.
Introduced on the S4810 and Z9000.
Introduced on the E-Series TeraScale.
Introduced on the S4820T.
– configures an IPsec encryption policy on an OSPFv3
– display the configuration of IPsec encryption policies.
1229