Clear Ipv6 Ospf Process; Debug Ipv6 Ospf Bfd - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

clear ipv6 ospf process

Reset an OSPFv3 router process without removing or re-configuring the process.

clear ipv6 ospf process

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.1.

Version 7.8.1.0

Version 7.4.1.0

Display debug information and interface types for bidirectional forwarding detection (BFD) on OSPF IPv6

[no] debug ipv6 ospf bfd [interface]

EXEC Privilege

Introduced on the S4810 and Z9000.

Introduced on the S4820T.

Added support for C-Series.

Introduced on the E-Series.

(OPTIONAL) Enter one of the following keywords and slot/

port or number information:

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a tunnel interface, enter the keyword tunnel then a

number. The range is from 1 to 16383.

For a VLAN, enter the keyword vlan then a number from

Open Shortest Path First (OSPFv2 and OSPFv3)