Ip Host - Dell S4810 Reference Manual

name
Defaults None
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage Use this command to add domain names to the DNS lists corresponding to a
Information specific VRF. You can add up to a maximum of six domain names to the DNS list
corresponding to a VRF. This domain is used to complete the unqualified host
names.
Example
Dell(conf)#ip domain-list
Dell(conf)#ip domain-list

ip host

Configures a mapping between the host name server and the IP address for a specific VRF. This mapping
information is used by the name-to-IP address table to resolve host names.
S4810
Syntax
ip host [vrf vrf-name] name ip-address
To undo the host name server to IP address mapping for VRFs, use the no ip
host [vrf vrf-name] name ip-address command.
Parameters
vrf vrf-name
name
ip-address
Defaults None
Command CONFIGURATION
Modes
634
Enter the name of the domain to be appended to the DNS
list corresponding to the VRF.
Introduced on the S-Series and Z-Series.
vrf jay dell.com
vrf jay force10.com
(Optional) Enter the key word vrf and then the name of the
VRF to configure the name server to IP address mapping for
that VRF.
Enter the name od the host to be associated with an IP
address.
Enter the IP address of the name server in dotted decimal
format.
Dynamic Host Configuration Protocol (DHCP)