Ip Msdp Peer - Dell S4810 Reference Manual

ip msdp peer

Configure an MSDP peer.
S4810
Syntax
ip msdp peer peer address [connect-source] [description] [sa-
limit number]
To remove the MSDP peer, use the no ip msdp peer peer address
[connect-source interface] [description name] [sa-limit number]
command.
Parameters
peer address
connect-
source
interface
description
name
sa-limit
number
Defaults As described in the Parameters section.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
1108
Enter the peer address in a dotted decimal format (A.B.C.D.).
Enter the keywords connect-source then one of the
interfaces and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet then the slot/ port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
(OPTIONAL) Enter the keyword description then a
description name (maximum 80 characters) to designate a
description for the MSDP peer.
(OPTIONAL) Enter the maximum number of SA entries in SA-
cache. The range is from 1 to 500000. The default it
500000.
Introduced on the S6000.
Multicast Source Discovery Protocol (MSDP)