Timers Basic - Dell S4810 Reference Manual

Example
show running-config rip
!
router rip

timers basic

Manipulate the RIP timers for routing updates, invalid, holddown times, and flush time.
S4810
Syntax
timers basic update invalid holddown flush
To return to the default settings, use the no timers basic command.
Parameters
update
invalid
holddown
flush
Defaults
•
•
•
•
Routing Information Protocol (RIP)
distribute-list Test1 in
distribute-list Test21 out
network 10.0.0.0
passive-interface GigabitEthernet 2/0
neighbor 20.20.20.20
redistribute ospf 999
version 2
Enter the number of seconds to specify the rate at which RIP
routing updates are sent. The range is from zero (0) to
4294967295. The default is 30 seconds.
Enter the number of seconds to specify the time interval
before routing updates are declared invalid or expired. The
invalid value should be at least three times the update timer
value. The range is from zero (0) to 4294967295. The default
is 180 seconds.
Enter the number of seconds to specify a time interval during
which the route is marked as unreachable but still sending
RIP packets. The holddown value should be at least three
times the update timer value. The range is from zero (0) to
4294967295. The default is 180 seconds.
Enter the number of seconds to specify the time interval
during which the route is advertised as unreachable. When
this interval expires, the route is flushed from the routing
table. The flush value should be greater than the update
value. The range is from zero (0) to 4294967295. The default
is 240 seconds.
update = 30 seconds
invalid = 180 seconds
holddown = 180 seconds
flush = 240 seconds
1405