Snmp Trap Link-Status - Dell S4810 Reference Manual

Related show snmp user
Commands

snmp trap link-status

Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
S4810
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status
command.
Defaults Enabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage If the interface is expected to flap during normal usage, you could disable this
Information command.
Syslog Commands
The following commands allow you to configure logging functions on all Dell Networking switches.
1580
— displays the information configured on each SNMP user name.
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Simple Network Management Protocol (SNMP) and Syslog