Spanning-Tree Pvst - Dell S4810 Reference Manual

Edge port:no (default) port guard :none (default)
Link type: point-to-point (auto) bpdu filter:disable (default)
Bpdu guard :disable (default)
Bpdus sent 1, received 0
Interface Designated
Name
---------------------------------------------------------
Gi 1/0 128.1223 128 20000 EDS 0 32768 0001.e800.a12b 128.1223
Example
Dell#show spanning-tree pvst vlan 5 guard
(Guard)
Interface
Name
-----------------------------------
Gi 0/1 5
Gi 0/2 5
Gi 0/3 5
Related

spanning-tree pvst

Commands
spanning-tree pvst
Configure a PVST+ interface with one of these settings: edge port with optional bridge port data unit
(BPDU) guard, port disablement if an error condition occurs, port priority or cost for a VLAN range, loop
guard, or root guard.
S4810
Syntax
spanning-tree pvst {edge-port [bpduguard [shutdown-on-
violation]] | err-disable | vlan vlan-range {cost number |
priority value} | loopguard | rootguard}
Parameters
edge-port
bpduguard
shutdown-on-
violation
err-disable
1318
PortID Prio Cost
Instance Sts
INCON(Root) Rootguard
FWD
EDS(Shut)
— configure PVST+ on an interface.
Enter the keywords edge-port to configure the interface as
a PVST+ edge port.
Enter the keyword portfast to enable Portfast to move the
interface into Forwarding mode immediately after the root
fails.
Enter the keyword bpduguard to disable the port when it
receives a BPDU.
(OPTIONAL) Enter the keywords shutdown-on-violation
to hardware disable an interface when a BPDU is received
and the port is disabled.
Enter the keywords err-disable to enable the port to be
put into the error-disable state (EDS) if an error condition
occurs.
Sts Cost Bridge ID
Guard type
Loopguard
Bpduguard
Per-VLAN Spanning Tree Plus (PVST+)
PortID