Match Ip Precedence - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.5(0.0)

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

To access this command, enter the class-map command. After the class map is

identified, you can configure the match criteria.

The match ip dscp and match ip precedence commands are mutually

Up to 64 IP DSCP values can be matched in one match statement. For example, to

indicate IP DCSP values 0 1 2 3 4 5 6 7, enter either the match ip dscp

0,1,2,3,4,5,6,7 or match ip dscp 0-7 command.

match ip precedence

Use IP precedence values as a match criteria.

match {ip | ipv6 | ip-any} precedence ip-precedence-list [set-

ip-dscp value]

To remove IP precedence as a match criteria, use the no match {ip | ipv6 |

ip-any} precedence ip-precedence-list [[multicast] set-ip-dscp

value] command.

Added the ipv6 and ip-any options on the Z9000, S6000,

S4820T, S4810, MXL.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

NOTE: Only one of the IP DSCP values must be a successful match criterion,

not all of the specified IP DSCP values must match.

— identifies the class map.

Enter the keyword ip to support IPv4 traffic.

Enter the keyword ipv6 to support IPv6 traffic.

Enter the keyword ip-any to support IPv4 and IPv6 traffic.

Quality of Service (QoS)