Logging Trap - Dell S4810 Reference Manual

Command LINE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
When you enable logging synchronous, unsolicited messages appear between
Information
software prompts and outputs. Only the messages with a severity at or below the
set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are
discarded, a system message appears on that terminal line. Messages may continue
to appear on other terminal lines.
Related
logging on
Commands

logging trap

Specify which messages are logged to the Syslog server based the message severity.
S4810
Syntax
logging trap [level]
To return to the default values, use the default logging trap command.
To disable logging, use the no logging trap command.
Parameters
level
Defaults 6 or informational
1596
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— enables logging.
Indicate a value from 0 to 7 or enter one of the following
parameters: emergencies, alerts, critical, errors,
warnings, notifications, informational, or
debugging. The default is 6 or informational.
Simple Network Management Protocol (SNMP) and Syslog