Fefd Interval; Fefd Mode - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

fefd interval

Set an interval between control packets.

fefd interval seconds

To return to the default value, use the no fefd interval command.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.11.1

Version 8.3.7.0

Change the FEFD mode on an interface.

fefd mode {normal | aggressive}]

To return the FEFD mode to the default of normal, use the no fefd mode

— enables FEFD globally on the system.

— changes FEFD mode on an interface.

Enter a number as the time between FEFD control packets.

The range is from 3 to 300 seconds. The default is 15

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

— enables far-end failure detection.