Mode - Dell S4810 Reference Manual

Command LLDP (conf-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2)
Usage
To enable LLDP on the management interface, use the no disable command in
Information
LLDP-MANAGEMENT-INTERFACE mode (conf-lldp-mgmtIf).

mode

To receive or transmit, set LLDP.
S4810
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx
rx
Defaults Both transmit and receive.
Command CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
Link Layer Discovery Protocol (LLDP)
Introduced on the Z9000 and S4810.
Enter the keyword tx to set the mode to transmit.
Enter the keyword rx to set the mode to receive.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1077