Ip Pim Ingress-Interface-Map - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.7.1.0
Example
Dell(conf)# ip access-list extended iptv-channels
Dell(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
Dell(config-ext-nacl)# permit ip any 232.1.1.0/24
Dell(config-ext-nacl)# permit ip 100.1.1.0/16 any
Dell(config-if-gi-1/1)# ip pim join-filter iptv-channels in
Dell(config-if-gi-1/1)# ip pim join-filter iptv-channels out
Related ip access-list extended
Commands protocols.

ip pim ingress-interface-map

When the Dell Networking system is the RP, statically map potential incoming interfaces to (*,G) entries
to create a lossless multicast forwarding environment.
S4810
Syntax
ip pim ingress-interface-map std-access-list
Parameters
std-access-list
Defaults none
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version 8.4.1.0
PIM-Sparse Mode (PIM-SM)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series for the port-channels and the S-
Series.
Introduced on the E-Series.
— configure an access list based on IP addresses or
Enter the name of a standard access list.
Introduced on the S4820T.
Introduced on the S4810.
Introduced
1275