Dell S4810 Reference Manual page 1189

Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage If you delete all the network area commands for Area 0, the show ip ospf
Information
command output does not list Area 0.
The following describes the show ip ospf command shown in the following
example.
Line Beginning
with
"Routing
Process..."
"Supports only..."
"SPF schedule..."
"Convergence
Level"
"Min LSA...."
"Number of..."
Example
Dell#show ip ospf 10
Routing Process ospf 10 with ID 1.1.1.1 Virtual router default-
vrf
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 0
Min LSA origination 0 msec, Min LSA arrival 1000 msec
Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
Number of area in this router is 1, normal 1 stub 0 nssa 0
Dell#
Related
show ip ospf database
Commands
show ip ospf interface
show ip ospf neighbor
Open Shortest Path First (OSPFv2 and OSPFv3)
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the OSPF process ID and the IP address associated
with the process ID.
Displays the number of Type of Service (TOS) rouse
supported.
Displays the delay and hold time configured for this process
ID.
Displays the intervals set for LSA transmission and
acceptance.
Displays the number and type of areas configured for this
process ID.
Area BACKBONE (0)
Number of interface in this area is 1
SPF algorithm executed 205 times
Area ranges are
— displays information about the OSPF routes configured.
— displays the OSPF interfaces configured.
— displays the OSPF neighbors configured.
1189