Clns Host; Debug Isis - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

clns host

Define a name-to-network service mapping point (NSAP) that you use with commands that require

NSAPs and system IDs.

clns host name nsap

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

To configure a shortcut name that you can use instead of entering a long string of

numbers associated with an NSAP address, use this command.

hostname dynamic

domain and allows the routers to advertise the host names in LSPs.

Enable debugging for all IS-IS operations.

To disable debugging of IS-IS, use the no debug isis command.

Enter an alphanumeric string to identify the name-to-NSAP

Enter a specific NSAP address that is associated with the

name parameter.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

— enables dynamic learning of host names from routers in the

Intermediate System to Intermediate System (IS-IS)