Link Aggregation Control Protocol (Lacp); Clear Lacp Counters - Dell S4810 Reference Manual

Link Aggregation Control Protocol (LACP)

This chapter contains commands for Dell Networks's implementation of the link aggregation control
protocol (LACP) for creating dynamic link aggregation groups (LAGs) — known as "port-channels" in the
Dell Networking operating software. The LACP commands in this chapter are supported by Dell
Networking OS on the S4810 platform.
NOTE: For static LAG commands, refer to
based on the standards specified in the IEEE 802.3 Carrier sense multiple access with collision
detection (CSMA/CD) access method and physical layer specifications.

clear lacp counters

Clear port channel counters.
S4810
Syntax
clear lacp port-channel-number counters
Parameters
port-channel-
number
Defaults Without a Port Channel specified, the command clears all Port Channel counters.
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Link Aggregation Control Protocol (LACP)
Port Channel Commands
Enter a port-channel number. The range is from 1 to 128.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
in the Interfaces chapter),
32
1021