Advertise - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:
Table of Contents

Advertisement

Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 7.5.1.0
Usage
To perform protocol-support consistency checks on hello packets, use this
Information
command. The adjacency-check is enabled by default.

advertise

Leak routes between levels (distribute IP prefixes between Level 1 and Level 2 and vice versa).
S4810
Syntax
advertise {level1-into-level2 | level2-into-level1} prefix-
list-name
To return to the default, use the no advertise {level1-into-level2 |
level2-into-level1}[prefix-list-name] command.
Parameters
level1-into-
level2
level2-into-
level1
prefix-list-
name
Defaults
level1-into-level2 (Level 1 to Level 2 leaking enabled.)
Command
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
954
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series.
Enter the keywords level1-into-level2 to advertise
Level 1 routes into Level 2 LSPs. This setting is the default.
Enter the keywords level2-into-level1 to advertise
Level 2 inter-area routes into Level 1 LSPs. This behavior is
described in RFC 2966.
Enter the name of a configured IP prefix list. Routes meeting
the criteria of the IP Prefix list are leaked.
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Introduced on the S6000.
Introduced on the S4820T.
Intermediate System to Intermediate System (IS-IS)

Advertisement

Table of Contents
loading

Table of Contents