Command
EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
debug arp
View information on ARP transactions.
S4810
Syntax
debug arp [interface] [count value]
To stop debugging ARP transactions, use the no debug arp command.
Parameters
interface
IPv4 Routing
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter the following keywords and slot/port or
number information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
Gigabitethernet then the slot/port information.
•
For the Management interface, enter the keyword
ManagementEthernet then the slot/port information.
The slot range is from 0 to 1 and the port range is 0.
•
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from
1 to 4094.
841