Rate-Police - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

rate-police

Specify the policing functionality on incoming traffic.

rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-

rate [burst-KB]]

peak peak-rate

Burst size is 100KB. peak-rate is by default the same as committed-rate.

Granularity for committed-rate and peak-rate is Mbps unless you use the kbps

QOS-POLICY-IN

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

The default burst size is 100Kb. If a different value is required, you must configure

the burst size to the required value.

Quality of Service (QoS)

NOTE: The multicast-bandwidth option is not supported on queue

ingress. If you attempt to use the multicast-bandwidth option, the

following reject error message is generated: % Error:Bandwidth-percent

is not allowed for ingress multicast.

Enter the keyword kbps to specify the rate limit in Kilobits

per second (Kbps). Make the following value a multiple of 64.

The range is from 0 to 40000000. The default granularity is

Megabits per second (Mbps).

Enter the bandwidth in Mbps. The range is from 0 to 40000.

(OPTIONAL) Enter the burst size in KB. The range is from 16

to 200000. The default is 100.

(OPTIONAL) Enter the keyword peak then a number to

specify the peak rate in Mbps. The range is from 0 to 40000.

The default is the same as designated for committed-rate.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.