Vlan Hello-Time - Dell S4810 Reference Manual

Parameters
vlan vlan-range
forward-delay
seconds
Defaults 15 seconds
Command CONFIGURATION (conf-pvst)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.1
Related
vlan bridge-priority
Commands

vlan hello-time

vlan max-age
show spanning-tree pvst
vlan hello-time
Set the time interval between generation of PVST+ 7 BPDUs.
S4810
Syntax
vlan vlan-range hello-time seconds
To return to the default value, use the no vlan hello-time command.
1324
Enter the keyword vlan then the VLAN numbers. The range
is from 1 to 4094.
Enter the keywords forward-delay then the time interval,
in seconds, that Dell Networking OS waits before
transitioning PVST+ to the forwarding state. The range is
from 4 to 30 seconds. The default is 15 seconds.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
— sets the bridge-priority value.
— changes the time interval between BPDUs.
— changes the time interval before PVST+ refreshes.
— displays the PVST+ configuration.
Per-VLAN Spanning Tree Plus (PVST+)