Ip Rip Send Version - Dell S4810 Reference Manual

2
Defaults RIPv1 and RIPv2
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage If you want the interface to receive both versions of RIP, use the ip rip receive
Information version 1 2 command.
Related

ip rip send version

Commands
version
ip rip send version
To send a specific version of RIP, set the interface. The version you set on the interface overrides the
version command in ROUTER RIP mode.
S4810
Syntax
ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
Parameters
1
2
1390
(OPTIONAL) Enter the number 2 for RIP version 2.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— sets the RIP version for sending RIP traffic on an interface.
— sets the RIP version the switch software uses.
(OPTIONAL) Enter the number 1 for RIP version 1. The
default is RIP version 1.
(OPTIONAL) Enter the number 2 for RIP version 2.
Routing Information Protocol (RIP)