Role - Dell S4810 Reference Manual

Defaults 15
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0)
Version 9.2(1.0)
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series
Usage Users entering EXEC Privilege mode or any other configured privilege level can
Information access configuration commands. To protect against unauthorized access, use the
enable password command to configure a password for the enable command
at a specific privilege level. If no privilege level is specified, the default is privilege
level 15.
Related enable password
Commands
access a privilege level.

role

Changes command permissions for roles.
Syntax role mode { { { addrole | deleterole } role-name } | reset } command
To delete access to a command, use the no role mode role-name
1530
Added support for roles on the Z9000, S6000, S4820T,
S4810, MXL
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Original command.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do
not need to enter an enable password.
— configures a password for the enable command and to
Security