Version 8.3.7.0
Version 8.2.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.1.1.0
Usage
The interface must be enabled to run the test or an error message is generated:
Information
Dell#tdr-cable-test gigabitethernet 5/2
%Error: Interface is disabled GI 5/2
The S-Series does not generate log messages is generated when the link flaps
down/up during TDR tests.
Related
show tdr
Commands
show tdr
Display the TDR test results.
S4810
Syntax
show tdr interface
Parameters
interface
Defaults
none
Command
EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.7.1.0
Version 7.6.1.0
Interfaces
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— displays the results of the TDR test.
Enter the keyword GigabitEthernet then the slot/port
information for the 100/1000 Ethernet interface.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
815