Advertise Med Voice-Signaling - Dell S4810 Reference Manual

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Related
debug lldp interface
Commands
show lldp neighbors

advertise med voice-signaling

To advertise when voice control packets use a separate network policy than voice data, configure the
system.
S4810
Syntax
advertise med voice-signaling {vlan-id layer2_priority
DSCP_value} | {priority-tagged number}
To return to the default, use the no advertise med voice-signaling
{vlan-id layer2_priority DSCP_value} | {priority-tagged number}
command.
Parameters
vlan-id
layer2_priority
DSCP_value
priority-tagged
number
Defaults unconfigured.
Command CONFIGURATION (conf-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
1092
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series and E-Series.
— debugs LLDP.
— displays the LLDP neighbors.
Enter the VLAN ID. The range is from 1 to 4094.
Enter the Layer 2 priority (C-Series and E-Series only). The
range is from 0 to 7.
Enter the DSCP value (C-Series and E-Series only). The range
is from 0 to 63.
Enter the keywords priority-tagged then the Layer 2
priority. The range is from 0 to 7.
Introduced on the S6000.
Introduced on the S4820T.
Link Layer Discovery Protocol (LLDP)